G652D ADSS Outdoor Fiber Optic Cable All Dielectric Self Supporting
All Dielectric Self-Supporting ADSS Fiber Optical Cable outdoor Aerial ADSS 48 96 Core Fibra Optica ADSS
Fiber Optical Cable
1. Can be installed without shutting off the power;
2.The maximum inductive at the operating point of AT sheath can reach 25kV;
3.Light weight and small diameter reducing the load caused by ice and wind and the load on towers and backprops;
4. Large span lengths and the largest span is over 1000m;
Fiber Optical Cable Specification:
| Installation Method |
| Typically used in areas with high electrical field strength or frequent lightning in the power communication transmission system. |
| Transport/Storage temp | －30℃~+65℃ |
| Installation temp | －20℃~+50℃ |
| Operation temp | －30℃~+65℃ |
| |
| Structural Characteristics |
| Fiber Count | 2~144 |
| Loose Tube | Colored fiber in PBT loose tube,filled with fiber gel |
| Aomor | Single fine steel wire and corrugated steel-plastic tape |
| Waterproof Layer | Cable core filled with cable gel or water blocking tape,water blocking yarns. |
| High-strength Aramid Yam | Offers very high tensile strength,small diameter and light weight to fit different climate consitions and laying spans |
| Sheath | Anti-tracking(AT) material or Polyethylene(PE) |
| |
| Technical Data |
| Item | Parameter | Item | Parameter |
| Cable type | ADSS-PE/AT24B1-12kN(typical) | Young's modulus(GPa)full cable cross-section | 8~20depending on span,load,ect |
| Fiber attenuation(B1)(dB/km) | 1310nm | ≤0.36 |
| 1350nm | ≤0.22 | Thermal expansion coefficient(10'/℃) | ≤10 |
| Nominal cable outer dia(mm) | 13(typical) | Min.bending radius(mm) | |
| Nominal thickness of outer sheath(mm) | ≥1.7 | | 100-1000 |
| Cable weight(kg/km) | 80~180 |
